Change TTX location at Run-Time - Please Help.... 
Author Message
 Change TTX location at Run-Time - Please Help....


After a struggle, I have finally managed to get a report and sub-report
running, using a TTX file and an active ADO recordset for the data
source. Works great, right up until I need to change the location of
the TTX file (e.g. when I install the VB project in a different
directory). I am creating the report using the Designer in VB6, and am
displaying it using the ReportViewer control in a form. Any help would
be greatly appreciated, as the Seagate manuals/Knowledge Base seem to
be devoid of this subject matter....... :(

Tim Pascoe
GIS and Environmental Applications Specialist
National Water Research Institute
Canada Center for Inland Waters

Sent via http://www.*-*-*.com/
Before you buy.

Sat, 11 May 2002 03:00:00 GMT  
 [ 1 post ] 

 Relevant Pages 

1. 1 * NcLpKzist-Changing Location of Field Definition File (TTX) at Runtime

2. Changing Location of Field Definition File (TTX) at Runtime

3. Run Time Change of DB Location, Setting Passwords, and Rpt Location

4. Crystal Report - CHange TTX location in code

5. TTX File - Change Location = Can't

6. How to change Database location at run time

7. CR9 does not change table location at run time

8. Changing database location at run-time

9. Changing database location at run time

10. Changing Access mdb location in run time

11. Change Database Location at run-time

12. Changing Database\Table locations at run-time from VB6


Powered by phpBB® Forum Software