I have just upgraded a CR 6.0 report to CR 7.0 by simply opening the
report in CR 6.0 and saving it in CR 7.0. No problems here.

    When I went to run the report from my VB 5.0 app. I noticed that alot of
my lines and boxes were overdrawn or were too short, basically the
formatting had gone a bit haywire.

    However when I viewed the report in design mode in CR 7.0 everything was
fine.

Is this a bug in CR 7.0 (maintenance release ) ?

Any Suggestions ???

Thanks in Advance

Aidan