hi.
i hope this is the correct NG for my problem: I created a 10x10cm box with
xfig and wanted to export that to .eps. this works fine but there's a
problem now: when I use pstricks (latex) in combination with my .eps file
both files doesnt begin exactly in the lower left corner. the .eps file is
a bit too high (maybe 3pt...). This is not much on 1cm but on the whole
picture I get a difference of several mm. I exported the picture using .eps
with 0pt border margin. nevertheless: when I open the exported .eps file
there's a small border: the box doesnt start at 0x0.
I use Xfig 3.2 patchlevel 3c here.
Maybe somebody knows a solution. Would be nice if the coordinates of both
packets are the same ...
Thanks.
--
MfG,
M. Hagedorn