Using Labview 5.1 to run SSR board and modules 
Author Message
 Using Labview 5.1 to run SSR board and modules


What behavior are you seeing?  What behavior are you expecting?  Which
VIs are you using in labview to control the SSR modules?  Can you
control the SSR modules from your DAQ board's test panel in
Measurement & Automation Explorer?

Spencer S.

Sat, 10 Dec 2005 05:55:00 GMT  
 Using Labview 5.1 to run SSR board and modules
Thanks for your reply.  Sorry didn't get back to you earlier.  But you
made me stop and think about the behavior.  And I released that I
hadn't put a module in the board nor power to it.  Let me play with it
some more and see what happens.  Thanks.

Sun, 11 Dec 2005 20:43:40 GMT  
 [ 2 post ] 

 Relevant Pages 

1. using GPIB device in LABVIEW 5.1

2. Using AT-A2150 with Labview 5.1

3. LabView 5.1 <--> LabView 6i

4. Compiling in Labview 5.1 after installing Labview 6.0i

5. convert's labview 6.1 vi's to labview 5.1 vi's

6. Using LabVIEW to communicate with custom board

7. Graphs in Reports of Labview 5.1

8. LabVIEW 5.1 Application Crash

9. Labview 5.1 and GPIB

10. exponential window in Labview 5.1

11. LabVIEW 5.1 Application builder

12. renaming directory in Labview 5.1


Powered by phpBB® Forum Software