using multiple event structures polling for panel closing event 
Author Message
 using multiple event structures polling for panel closing event

Use a single event structure. Create an event for Value changed of the
Boolean and put your logic in there or just put the case outside the
event structure. The labview help contains a section called "Caveats
and Recommendations when Using Events in LabVIEW" and one of the
topics is "Avoid placing two Event structures in one loop.


Mon, 22 Aug 2005 03:30:59 GMT  
 using multiple event structures polling for panel closing event
Thanks Dennis. There was some misleading info on the developer zone,
but an NI engineer set me straight.
cheers.


Mon, 22 Aug 2005 03:50:42 GMT  
 
 [ 2 post ] 

 Relevant Pages 

1. Event structure and updating front panel

2. Event structure always capturing events, no matter where it is placed in a VI

3. Boolean controls don't respond to input when inside an event in the event structure

4. Event Structure and Events

5. Single Event -> Multiple Event

6. multiple event structures

7. Tcl Event Loop vs TK Event Loop issues with Asynchronous Events

8. Pass data between subVIS using Event structures.

9. Using an Event Structure to sense selection of a ring control

10. Event case loses connection to data structure when data structure is modified

11. Event structure is not visible in the structures pallete

12. Is there a way to add an event to the event queue handled by the event structure?

 

 
Powered by phpBB® Forum Software