Solution for NESTED TOO DEEP 
Author Message
 Solution for NESTED TOO DEEP

If you have a main menu and want to go to next one, typical way
is to issue the command: "do Next.SPR"
However, if you have too many DOs, then it will give you that
error message, my solution is:
In Main Menu Command Button: Valid:
don't issue the clear read command, just say :
Hide Window Main
DO Next.SPR
in the Next Screen ,if you finish the work and want to return
to main, just  say: "clear read" in Valid clause
in Cleanup section, type: "Active Window Main"

That's it!

Good Luck, this solution will fit most of the situations unless
you have over 32-level deep subscreens.

Alex



Tue, 02 Dec 1997 03:00:00 GMT  
 
 [ 1 post ] 

 Relevant Pages 

1. Do nesting too deep on ON KEY LABEL

2. Do nesting too deep on ON KEY LABEL -Reply

3. nesting too deep

4. DO NESTING TOO DEEP

5. FPW2.6a Do nesting too deep

6. Do nesting too deep

7. "Do nesting too deep"

8. Help."Do nesting too deep"

9. do nesting too deep followup

10. do nesting too deep in foxpro 2.5 for dos

11. Do nesting too deep??

12. Do Nesting Too Deep

 

 
Powered by phpBB® Forum Software