i get the following error in combination with Clipper 5.3a, CA-Tools 3.0b
and Exospace:

Error [35]: General protection fault in E:\BIO.EXE at 03F7:0B08
code 0000 SS=0B57 DS=0B57 ES=0BC7  load base=014F
AX=0002 BX=7796 CX=FFFF DX=FFFF SP=76FC BP=770A SI=0318 DI=77F8

My link-file:

EXOSPACE EXECUTABLE NODELETE
FILE bio,f1,f2,f3,f4,f5,f6,f7,f8,f9,reorg,auswmenu,__wait_b,ctintp,ctusp
LIBRARY clipper,extend,ctp

Does anyone know this problem ? Many thanks for your help !!!!!!!

Best regards,
Thomas

1) Upgrade your Clipper to 5.3b
2) Upgrade your CA-Tools to IIIc
3) Include Terminal.lib before CTP
4) Caution with CTINTP and CTUSP
5) Try running OPEDIT on you .EXE (instrucions on the manuals
and "readmes"

HTH

Marcos Nogueira
S. Paulo - Brazil

* Sent from RemarQ http://www.remarq.com The Internet's Discussion Network *
The fastest and easiest way to search and participate in Usenet - Free!

Thank you very much for your help. I proceeded your points, but the problem
still appear. I found out, that the function VOLSERIAL() from the CA-Tools
causes the GPF.

My CTP.LIB has a size 436.389 bytes, and is from 08. February 2000 with time
3:53 (downloaded from an internet-homepage).

Can you help me ?? Thank you very much,

Best regards,
Thomas

After moving from ExoSpace to Blinker (now v5.1), I get no GPFs
in any CA Tools functions.

HTH

Marcos Nogueira
S. Paulo - Brazil

* Sent from RemarQ http://www.remarq.com The Internet's Discussion Network *
The fastest and easiest way to search and participate in Usenet - Free!