Hi,

There probably isn't any solution to this answer, but I thought I'd make
sure anyway.  I have a listview control, set always in report view.  It
works fine, except if you scroll down, then scroll back up again, there are
ugly black lines in between each item.  They will go away with a simple
.refresh, but I can't work out where to put a command like that.

If I put it in the mousemove event of that listview, it will flicker
whenever the mouse goes over it.  If I put it in a timer, it still flickers
on the interval.

Has anyone else encountered this problem?

Thanks anyway,
Xander.

--------------
Xander Holkner

WWW:   http://www.*-*-*.com/ ~xander/
MOO:   http://www.*-*-*.com/ :4243/

This is an ugly bug that wouldn't go away until I put my listview control
in a frame and turned 3d and border off on the listview control...
However, I just tried to duplicate the problem and can't make it come back!

Go Figure :|