I have struggled through the CR development of a simple report in VB
6.0. I am using the development environment in VB, and have based my
report on a TTX file. I am using an ADO recordset to populate the
report at run-time. This is all great, right up until the location of
the TTX file changes, as in when the software is installed. I know I
can generate the TTX file on the fly in code from the ADO recordset,
but how do I tell the *$#**!! report where to look for it? All of the
SetDataSource and related procedures seem to relate only to a
recordset, not a file location!

Any help would keep me from taking a bat to my CR installation CD, and
then burning what was left......

--
Tim Pascoe
GIS and Environmental Applications Specialist
National Water Research Institute
Canada Center for Inland Waters

Sent via Deja.com http://www.*-*-*.com/
Before you buy.