Hi

I've just upgraded from VB3.0/Access2.0 to VB4.0/Access'95 and I have a
problem running a report created in Crystal Reports. It works fine in CR
itself, but when I run the project it comes up with a 'Run-time Error of
20000' which is nowhere documented in CR help. Does anyone have any
ideas, I'd be very grateful ?

Nick
***********************************************************************
* Nick Boddington           * 'Life is what happens while you are busy*

***********************************************************************    

I encountered the same error, the solution is buried somewhere in the
documentation.
The fix, in my case anyway was to set the ReportSource property of the
report control to Report File.
Also make sure all the properties for the report control are correct, as
the documentation (sorry don't remember where) says that some of the
properties aren't converted properly from 3->4.

--
David W. Forest
LAN Specialist
Information Technologies
Lear Corporation - Ford Division
SBN Level 2
http://www.concentric.net/~dforest/

If you're not scared, you don't understand.