Preserving Code in Reverse Engineering 
Author Message
 Preserving Code in Reverse Engineering


Is there any way  in Visio 2002 tha I can preserve the
code written inside methods when I reverse engineer it
from C# or VB.NET.
I am very much concerned about it because if we write our
code and after sometime we need to make some changes in
our design by bringing it back in Visio we loose all our
code, which we write inside our methods.

Any solution of this problem ?



Sun, 19 Jun 2005 00:11:13 GMT  
 [ 1 post ] 

 Relevant Pages 

1. Reverse engineering Visual Basic Code

2. something like reverse engineering

3. Visio - Database Reverse Engineering

4. Reverse Engineering - Complications?

5. reverse and forward engineering

6. Reverse Engineer UML from VB6 behaves strange

7. ??UML Reverse Engineer Refresh???

8. Visio UMS reverse engineering

9. reverse engineering basic

10. Can you reverse engineer a quickbasic program?

11. Avoiding recompiling/reverse engineering

12. reverse engineering


Powered by phpBB® Forum Software