I have a document with pageorientation = Portrait.
I have created a macro  which add a new page with orientation = Landscape in
a new section.
The header/footer (in section 2), which is a table, is automatically
inserted on the new page.
The problem is that i want the table to expand to width = 26 cm only on the
page with orientation = Landscape, not only 16 cm as it is on pages with
orientation = Portrait.

Does anyone have a solution to this problem?

Thanks in advance

Unni

The reason that the table takes on the width of the portrait section is that
until is reset, the header will be formatted as Same as Previous.  If you
include the following line in your macro before you insert the table, the
table will be the full width of the Landscape orientation:

    Selection.HeaderFooter.LinkToPrevious = Not
Selection.HeaderFooter.LinkToPrevious

Hope this helps,
Doug Robbins - Word MVP
Please post any follow-up to the Newsgroups so that others may benefit
therefrom or contribute thereto.